Cable coaxial ALLNET ANT-CAB-RSMA-RSMA-500 R-SMA R-SMA 5 m negro

The ALLNET ANT-CAB-RSMA-RSMA-500 is a 5 m coaxial cable with R-SMA connectors on both ends and a black outer jacket. It is designed for RF signal transmission between antennas, radio modules, routers or other devices that accept R-SMA terminations. The cable provides a straightforward, fixed-length connection where a reliable low-loss link is required over a short to moderate distance.

Advantages

This coaxial cable features R-SMA connectors on each end to ensure a secure mechanical fit and consistent electrical contact. The 5 m length offers flexibility in device placement without excessive slack, and the black jacket provides a discreet appearance in installations. Constructed for typical RF use, the cable supports stable signal transfer appropriate for antenna and wireless equipment connections.

Suitable for

• Connecting antennas to routers, modems or wireless access points with R-SMA ports
• Linking radio modules, signal amplifiers or measurement equipment using R-SMA connectors
• Temporary or permanent cabling where a 5 m coaxial link is required

Key specifications

• Cable length: 5 m
• Connector type (end 1): R-SMA
• Connector type (end 2): R-SMA
• Product colour: Black

How to use

Verify that both devices have compatible R-SMA female or male ports as required by the connected equipment. Align each R-SMA connector with the mating connector and tighten by hand until finger-tight; avoid excessive torque. Route the cable to minimize sharp bends and avoid tight kinks that can impair RF performance. Ensure connections are made with powered equipment turned off when appropriate to prevent damage to connectors or devices.

Recommendations

For optimum signal integrity, keep the cable run as short as practical and avoid running coaxial cable parallel to mains power lines. Store and handle the cable without sharp folds; replace the cable if the outer jacket is damaged. When installing outdoors or in damp areas, use additional environmental protection at connectors to prevent moisture ingress.