Cable coaxial e+p AB 205 5 m DIN 45 325 blanco

The e+p AB 205 5 m DIN 45 325 White coaxial cable is a high-grade connection cable designed for TV and radio signal transmission. This 5-meter white cable features DIN 45 325 connectors on both ends and gold-plated contacts for reliable electrical contact. Double-shielded construction and a 75 Ω impedance support wide-band cable installations and digital-capable signal transfer. Ferrite cores at both ends reduce high-frequency interference and help maintain signal integrity. The cable is produced in compliance with WEEE and RoHS environmental standards.

Advantages

The cable combines gold-plated contacts with a double-shielded conductor to ensure low loss and consistent signal quality. Ferrites on both sides suppress electromagnetic interference and improve reception for digital and analog broadcasts. Its 75 Ω impedance and DIN 45 325 connectors make it compatible with common TV and radio equipment, while the white outer jacket offers a discreet appearance for visible installations.

Suitable for

• Connecting television sets to wall sockets or receivers in home and commercial settings
• Linking radio tuners and FM antennas requiring 75 Ω impedance
• Wide-band cable installations that require digital-capable coaxial connections
• Situations where reduced interference is needed, such as urban or electrically noisy environments

Key specifications

• Cable length: 5 m
• Connector type: DIN 45 325 plug and jack on opposite ends
• Impedance: 75 Ω
• Shielding: double-shielded construction
• Contacts: gold-plated
• Interference suppression: ferrite cores at both ends
• Compatibility: digital-capable for TV and radio signals
• Outer color: white
• Environmental compliance: WEEE and RoHS certified

How to use

Connect the DIN 45 325 plug to the output of the source device (for example a wall socket, antenna output or receiver) and insert the DIN 45 325 jack into the input of the TV, radio or tuner. Ensure connectors are fully seated and finger-tight to provide reliable contact; avoid excessive torque. Route the cable without sharp bends or kinks and keep it away from power cables and strong sources of electromagnetic interference for best performance.

Recommendations

For optimal signal quality, use this cable for short to medium runs up to 5 m and avoid routing alongside mains cables. If installed near large electrical equipment, confirm ferrite positions at both ends are intact. Replace the cable if connectors show visible wear or corrosion despite the gold plating.