Cable de audio Omnitronic 30220595 30 m XLR (3 polos) negro

The Omnitronic 30220595 30 m XLR (3-pin) Black audio cable provides a balanced analog connection between professional audio devices. Supplied with a male XLR (3-pin) and a female XLR (3-pin) connector, this 30 metre cable is designed to carry microphone-, line- and DI-level signals with minimized interference and stable contact. The black sheathing offers discreet appearance and mechanical protection for live sound, studio patching and installation use.

Advantages

This Omnitronic XLR cable uses a three-pin balanced configuration to reduce hum and noise over long runs. The length of 30 m allows flexible stage and studio routing while keeping signal integrity. Robust connectors and durable outer jacket increase reliability in repeated use and transport. The cable's construction supports consistent impedance and shielding to maintain audio quality across microphones, mixers and outboard gear.

Suitable for

Key specifications

How to use

Plug the male XLR connector into the output of the source device (for example a microphone preamp or DI box) and insert the female XLR connector into the input of the destination device (such as a mixing console or audio interface). Avoid sharp bends and kinks in the cable; coil or lay the cable flat when storing. For live setups, route the cable to minimize trip hazards and keep it away from power cables to reduce potential interference.

Recommendations

For best performance, use the cable with properly grounded equipment and avoid running it parallel to high-voltage power lines. Inspect connectors regularly for secure pins and replace the cable if shielding or jacket damage is visible. For repeated stage use, consider using cable ties or protective sleeves at stress points to extend service life.