Cable de audio ShiverPeaks 40103MHQ, 2 hilos, conector macho recto, 3,0 m

ShiverPeaks 40103MHQ is a 3.0 m, two-conductor audio cable with straight plugs designed to create a reliable analog connection between audio components. The cable offers a simple, low-profile solution for linking amplifiers, speakers, mixers and playback sources in short-run setups. Its length and construction make it practical for home audio systems, studio patching and live-sound rigs where a durable, predictable connection is required.

Advantages

The cable combines two conductors in a single jacket to carry stereo or balanced mono signals depending on system wiring, and its straight plugs provide a compact connection that fits standard jacks without adding bulk. The 3.0 m length offers flexibility for placement while remaining short enough to limit signal loss and interference in typical analog setups. Built with standard materials and connectors, the cable is easy to route and service and integrates with common audio equipment used in domestic, rehearsal and small live venues.

Suitable for

• Connecting amplifiers to speakers or powered monitors
• Patch connections on studio desks and audio racks
• Interfacing mixers with playback devices or instruments
• Short runs in home audio or multimedia setups

Key specifications

• Cable length: 3.0 m
• Conductors: two-core design
• Connector type: straight plugs
• Signal type: analog audio (stereo or wired mono)
• Typical use: short-run interconnection for audio components

How to use

Plug one straight connector into the output of the source device (for example, a mixer, playback unit or amplifier output) and insert the other straight connector into the input of the target device (speaker, amplifier input or recording device). Ensure connectors are fully seated and routed to avoid sharp bends or pinching. For balanced mono operation, follow your equipment’s wiring conventions; for stereo use, connect left and right channels as required. Inspect connectors and cable jacket periodically for wear and replace the cable if insulation or contacts show damage.

Recommendations

For the best analog signal integrity, keep the cable length as short as practical for the setup and avoid running it parallel to power lines. Use strain relief at connector ends when possible and store the cable coiled loosely to prevent kinks. When using in professional rigs, label both ends to speed identification during setup and teardown.