Cable de audio ShiverPeaks BS06-21106 25 m blanco

The ShiverPeaks BS06-21106 25m White audio cable is a long-length cable designed for audio and video installations where extended reach is required. Constructed with Copper-Clad Aluminium (CCA), this 25 meter cable provides a balance between conductivity and cost, and its white outer jacket integrates discreetly into many environments. The cable is sold without pre-attached connectors, allowing selection of connectors or termination methods appropriate to the installation.

Advantages

The CCA conductor offers lower weight compared with pure copper while maintaining adequate electrical conductivity for many audio transmission scenarios. The 25 m length supports flexible placement of audio equipment without the need for additional joins. The white jacket improves visual integration in light-coloured interiors or behind white skirting and panels. Supplied without connectors, the cable enables custom termination tailored to the specific devices and connector types required.

Suitable for

• Fixed audio installations in homes and small venues
• Running audio signals between wall plates and amplifiers
• Temporary setups where a single long run is preferable to multiple shorter cables
• Custom installations requiring selection of specific connectors or soldered terminations

Key specifications

• Cable length: 25 m
• Conductor type: Copper-Clad Aluminium (CCA)
• Colour: White outer jacket
• Connectors: none attached (sold as cable only)

How to use

Measure the required run and route the cable to avoid sharp bends, heat sources and moving parts. If walls or ceilings are used, secure the cable with appropriate clips or conduit to meet local installation practices. Terminate each end with the connector type compatible with your equipment or mount the cable into wall plates as needed. When soldering or crimping connectors, follow manufacturer instructions for conductor preparation to ensure reliable electrical contact and mechanical strain relief.

Recommendations

For longer-term or professional audio installations, verify that CCA conductor performance meets the system’s signal and impedance requirements; consider using quality connectors and secure routing to minimise signal loss and interference. Avoid running parallel to high-voltage power cables to reduce potential interference.