Cable de audio XLR de 3 polos Omnitronic 3022010L azul 3 m

The Omnitronic 3022010L Blue 3m is a balanced audio cable with XLR 3-pin connectors, supplied with a male connector on one end and a female connector on the other. At three metres in length, this cable is designed to link microphones, mixers, audio interfaces and other professional audio devices while maintaining signal integrity. The cable’s blue jacket provides clear visual identification in stage, studio or installation environments.

Advantages

This XLR cable provides balanced signal transmission to reduce noise and interference over moderate distances. The three-pin connectors ensure reliable mechanical contact and compatibility with standard pro-audio equipment. The cable’s construction balances flexibility and durability for repeated handling, and the coloured outer jacket simplifies cable management and quick identification during setup and teardown.

Suitable for

Key specifications

How to use

Connect the male XLR end to the input of the receiving device (for example, a mixer or preamp) and the female XLR end to the output device (for example, a microphone or DI box), or vice versa depending on the signal flow in your setup. Ensure connectors are fully seated and the latch clicks where present. Route the cable to avoid tight bends, pinch points and high-traffic areas to preserve cable life and maintain reliable signal transfer.

Recommendations

For best results, avoid running the cable parallel to mains power lines to reduce potential hum. Coil the cable using the over-under method when storing to prevent twists and extend service life. Inspect connectors periodically for dirt or damage and replace the cable if the jacket or connectors show significant wear.