Cable de conexión breakout BlueOptics OM4 Multimodo MPO/UPC a 4x Duplex LC/UPC 15 m, G50/125 µm, 3,0 mm LSZH, 8 fibras, MPO sin pines

Multimode BlueOptics OM4 breakout patch cable with MPO/UPC connector to 4x Duplex LC/UPC, 15 meters long. The cable uses G50/125µm OM4 multimode fiber with 8 cores and a 3.0 mm LSZH jacket in magenta. The MPO connector is supplied without pins. This breakout cable is designed for high-density data center and telecom trunking, short-reach multimode links, and fiber backbone connections. A test protocol is included to verify optical performance.

Advantages

The cable combines an MPO/UPC multi-fiber interface with four duplex LC/UPC terminations to simplify migration between trunk and equipment connections. OM4 multimode fiber provides improved bandwidth for short-reach applications, and the 3.0 mm LSZH jacket reduces smoke and toxic emissions in case of fire. The magenta jacket offers visual identification for OM4 fiber, while included test documentation supports installation verification and quality control.

Suitable for

Key specifications

How to use

Route the breakout cable from the MPO-enabled trunk or cassette to the target patch panel or equipment. Ensure the MPO end aligns with the MPO housing and that the mating connector type (without pins) matches the adapter or cassette used. Connect each duplex LC/UPC pair to the corresponding LC ports on switches or transceivers, observing transmit/receive orientation. After installation, use the supplied test protocol to confirm insertion loss and continuity across all eight fibers.

Recommendations

Handle MPO connectors carefully to avoid contamination; always inspect and clean fiber endfaces before mating. Maintain bend radius appropriate for multimode fiber and avoid tight bends near breakout points. Use compatible MPO adapters or cassettes designed for pinless MPO connectors. Store and route the cable in cable management systems to prevent mechanical stress.