Cable de conexión de satélite ShiverPeaks 80305 — conector F a conector F con pin central, 5 m

Coaxial satellite connection cable ShiverPeaks 80305 — F-connector to F-connector with central pin, 5 m is a shielded coax lead designed for linking satellite dishes, LNBs and satellite receivers. The cable features F-type terminations with a central pin to ensure correct signal transmission to devices that accept pin-style F-connectors. With a 5.0 m length, the cable suits typical in-home and short outdoor runs where a secure mechanical and electrical connection is required.

Advantages

The ShiverPeaks 80305 cable offers four-layer shielding and a braided design to minimize interference and maintain signal integrity. Gold-plated contacts and a central pin provide reliable conductivity and corrosion resistance for long-term use. A high shielding effectiveness (greater than 110 dB) reduces ingress of external RF noise, and the cable jacket is intended for both indoor routing and protected outdoor installations. The connector construction supports firm screw-type coupling typical for satellite F-connections.

Suitable for

• Connecting satellite dish LNB outputs to satellite receivers
• Extending existing satellite coax runs within a home
• Temporary outdoor routing between dish and wall entry point
• Installations requiring reliable F-connector with central pin

Key specifications

• Cable length: 5.0 m
• Connector type: F-connector to F-connector with central pin
• Shielding: 4-layer shielding (quad-shielded)
• Shielding effectiveness: >110 dB
• Contact finish: gold-plated contacts
• Mechanical coupling: screw-type F-connectors

How to use

Route the coaxial cable from the satellite dish or LNB to the receiver location, avoiding sharp bends and positions where the cable will be pinched or stressed. Screw the F-connector ends onto the mating F-type sockets of the dish, LNB or receiver until snug; do not overtighten to prevent damage to the connector or device. Confirm that the central pin is correctly seated where the receiving device requires a pin-style F-connection. After installation, check the signal level at the receiver to ensure the connection is functioning and make minor adjustments to connector seating if necessary.

Recommendations

For best performance, keep cable runs as short and straight as practical, secure the cable to avoid movement, and use weatherproofing tape or a suitable outdoor junction for any outdoor exposed termination. When joining segments, use quality F-type connectors and compression or soldered joints designed for quad-shield coax to maintain shielding performance.