Cable de fibra óptica InfiniBand BlueOptics CBL-0347L-BL 1 m SFP+ conector/conector

The BlueOptics CBL-0347L-BL is a 1 m InfiniBand/fibre optic cable with SFP+ connectors on both ends designed for short-reach, high-speed interconnects in data centers and networking racks. This male-to-male SFP+ cable supports 10G data transmission and is intended for direct attachment use between switches, routers, storage systems and other equipment that accept SFP+ interfaces. The cable’s construction and compliance with SFP+/DAC conventions make it suitable for low-latency electrical connections over short distances while maintaining compatibility with common hardware platforms.

Advantages

The cable offers a compact, single-cable solution for linking adjacent rack units or devices within the same rack with minimal latency and low power consumption. Built to meet industry SFP+/DAC conventions, it is compatible with systems that support 10GBase-CR and InfiniBand electrical interconnects. The 1 m length provides a tidy routing option for short connections and reduces excess cabling in dense installations. Components are selected to deliver stable signal integrity for typical data center workloads.

Key specifications

How to use

Install the BlueOptics CBL-0347L-BL by firmly inserting each SFP+ connector into the corresponding SFP+ port on your devices until the latch clicks into place. Ensure both devices are powered down or support hot-plugging according to the equipment manufacturer instructions before inserting or removing the cable. Verify link status and speed in device interfaces and management software; the cable is intended for short-distance direct attach use and should be routed to avoid sharp bends or mechanical stress.

Recommendations

For reliable operation, use this 1 m SFP+ cable only in environments and with hardware that explicitly support passive SFP+/DAC connections and 10GBase-CR or InfiniBand electrical protocols. Avoid tight bends, excessive tension, and exposure to liquids or extreme temperatures. When mixing vendor equipment, confirm compatibility in a lab or request a test sample to validate link stability before wide deployment.