Cable de fibra óptica InfiniBand BlueOptics UACC-AOC-QSFP28-10M-BO 10m conector macho/conector macho

The BlueOptics UACC-AOC-QSFP28-10M-BO is a 10-meter active optical cable (AOC) with QSFP28 male-to-male connectors designed for InfiniBand and 100G Ethernet applications. Built for data center and networking environments, this fibre optic cable uses multimode fibre and integrated transceivers on each end to support high-speed, short-reach links while minimising signal loss over the 10 m span.

Advantages

This cable provides a factory-tested QSFP28-to-QSFP28 connection compliant with Multi-Source Agreement (MSA) mechanical and electrical expectations, enabling straightforward integration with compatible networking equipment. The active optical design reduces electromagnetic interference and heat compared with equivalent copper assemblies, while the 10 m length offers flexible routing in racks and between devices. Designed to support high data rates such as 100GBASE-SR4, it is intended to deliver consistent performance for Ethernet, Fibre Channel over Ethernet and similar high-speed protocols.

Suitable for

Key specifications

How to use

Ensure both endpoints and the host devices support QSFP28 AOC modules and the intended 100G protocol before installation. Power off or follow hot‑swap procedures recommended by the hardware vendor, then insert the QSFP28 plugs into the corresponding QSFP28 ports until they latch. Verify link status through the host device management interface and monitor for expected operational indicators. For removal, follow vendor guidance to avoid damaging transceiver modules or port latches.

Recommendations

Install the cable in clean rack environments and avoid tight bends or kinks; maintain the manufacturer’s minimum bend radius. Use with devices that explicitly support QSFP28 AOC modules and confirm firmware compatibility if required.