Cable de red BlueOptics CB-M12-4LC-SMF10M MPO-4xLC monomodo 10 metros

The BlueOptics CB-M12-4LC-SMF10M MPO-4xLC Singlemode 10 Meter is a singlemode fiber patch cable designed for high-speed, low-loss optical connections in structured networks. With a 10 meter length and MPO to 4xLC termination, this cable supports dense fiber routing between equipment in data centers and enterprise environments while preserving signal integrity over singlemode links.

Advantages

This singlemode MPO to LC cable provides low attenuation and consistent optical performance for long-reach connections. The MPO-4xLC breakout simplifies connections to multiple LC ports from a single MPO interface, reducing cable congestion and installation time. The 10 m length offers flexibility for rack-to-rack or equipment-to-equipment cabling without intermediate splices, and the construction is intended for repeated handling in professional network environments.

Suitable for

Key specifications

How to use

Connect the MPO end to the MPO port on a switch, transceiver or patch panel, and plug the four LC connectors into the corresponding LC ports on the target device or panel. Ensure connector endfaces are clean and aligned before mating to minimize insertion loss. Route the cable along cable management paths, avoiding sharp bends and excessive tension to preserve optical performance. Verify connections using appropriate optical test equipment if required.

Recommendations

Maintain connector cleanliness using fiber-grade cleaning tools, avoid tight bends with a bend radius below manufacturer guidelines, and store or label cables clearly for efficient maintenance. Use this singlemode MPO-4xLC patch cable where multiple LC channels are required from a single MPO trunk in data center and enterprise optical infrastructures.