Cable de red EFB Elektronik RJ45 S/FTP Cat6a 7,5 m

The EFB Elektronik RJ45 S/FTP Cat6a networking cable, 7.5 m long, is designed for high-speed data transmission in structured networks. It uses S/FTP (PIMF) shielding and Cat6a construction to support frequencies up to 1000 MHz and reduce crosstalk and external interference. The cable is halogen-free and fitted with RJ45 connectors on both ends, coded to the TIA/EIA 568B standard for straightforward installation.

Advantages

S/FTP PIMF shielding provides improved protection against electromagnetic interference compared with unshielded cables. Cat6a specification and 1000 MHz rating enable reliable support for Gigabit and 10 Gigabit Ethernet links over short and medium distances. Halogen-free jacket reduces toxic gas emissions in case of fire. Pre-terminated RJ45 connectors ensure quick deployment and consistent connector quality.

Suitable for

• Office and data centre horizontal and patch cabling
• High-bandwidth applications such as 10 Gigabit Ethernet
• Environments where reduced electromagnetic interference is required
• Installations requiring TIA/EIA 568B wiring

Key specifications

• Length: 7.5 m
• Cable type: S/FTP (PIMF), Cat6a
• Frequency: up to 1000 MHz
• Connectors: RJ45 — 2x, TIA/EIA 568B coded
• Jacket: halogen-free
• Brand: EFB Elektronik
• MPN: K8050.7,5
• EAN: 4049759012908

How to use

Connect each RJ45 connector to the corresponding network port on devices such as switches, routers or patch panels following the TIA/EIA 568B wiring convention. Ensure connectors are fully seated and secured. Route the cable to avoid tight bends and sources of severe electromagnetic noise. For permanent installations, use appropriate cable management and strain relief to prevent damage to the connectors and cable sheath.

Recommendations

For optimal performance, keep cable runs within recommended lengths for Cat6a and avoid coiling excess cable tightly. Verify network equipment supports Cat6a or 10 Gigabit Ethernet where required. Inspect connectors before use and replace the cable if the jacket or connectors are visibly damaged.