Cable de red Gembird PP6U-CU-1M RJ-45 Cat6 1m gris

The Gembird PP6U-CU-1M RJ-45 Cat6 1m Grey is a 1-metre network patch cable engineered for reliable Ethernet connections in home and small office environments. Built to the Cat6 specification, the cable supports high-speed data transfer and reduced crosstalk compared with lower category cables. The U/UTP construction and gold-plated RJ-45 connectors provide stable signal transmission and improved contact resistance over repeated use.

Advantages

This Cat6 cable offers a compact 1 m length suitable for close-distance patching between switches, routers, patch panels and network devices. Gold-plated RJ-45 connectors enhance corrosion resistance and ensure consistent electrical contact. The U/UTP shielding reduces external electromagnetic interference, helping maintain throughput and connection stability. The grey outer jacket provides a neutral appearance that integrates easily into most installations.

Suitable for

• Connecting a desktop or laptop to a router or switch
• Patch panel to switch connections within a rack or cabinet
• Small office and home network patching where short runs are required
• Temporary connections for testing or configuration of network devices

Key specifications

• Cable category: Cat6
• Length: 1 m
• Connector type: RJ-45 to RJ-45
• Shielding: U/UTP (overall unshielded twisted pair with unshielded pairs)
• Contact plating: gold-plated contacts
• Colour: Grey

How to use

Insert the RJ-45 plug into the Ethernet port of your device until the latch clicks to secure the connection. Use this 1 m patch cable to connect network devices positioned close to each other, such as a switch to a patch panel or a router to a desktop. Avoid sharp bends near the connector ends and route the cable without excessive tension to preserve signal integrity. For best results, ensure connectors are fully seated and network ports are free of dust or debris before connecting.

Recommendations

For stable Gigabit performance, use this Cat6 cable for short runs up to 1 m between network equipment. Keep the cable away from strong sources of electromagnetic interference and avoid kinking or tightly coiling it. Periodically inspect connectors for wear and replace the cable if contact corrosion or physical damage is observed.