Cable de red LANBERG PCF5-10CC-0300-S Cat5e F/UTP RJ-45 3 m gris

The Lanberg PCF5-10CC-0300-S RJ-45 Cat5e 3 m Grey is a 3-metre network patch cable designed for Ethernet connections that require reliable data transmission and basic protection against electromagnetic interference. Built to the Cat5e standard with RJ-45 connectors on both ends, this F/UTP (FTP) shielded cable is suitable for connecting switches, routers, patch panels and network devices in home and office environments while maintaining a neat grey appearance.

Advantages

The F/UTP (FTP) shielding reduces susceptibility to external electromagnetic interference, helping to maintain signal integrity in environments with nearby electrical equipment. Compliance with Cat5e guidelines supports data rates commonly used in residential and small office networks. The 3 m length provides flexibility for typical desktop and rack connections without excessive cable slack, and the standard RJ-45 terminations ensure compatibility with a wide range of networking hardware.

Suitable for

• Connecting desktop computers to switches or routers
• Patch panel to switch connections in small racks
• Home network wiring where moderate cable length is required
• Office workstations and meeting rooms

Key specifications

• Length: 3 m
• Standard: Cat5e
• Shielding: F/UTP (FTP) — overall foil shield with unshielded pairs
• Connectors: RJ-45 on both ends
• Colour: Grey

How to use

Plug one RJ-45 connector into the Ethernet port of the source device (for example a switch or router) and the other connector into the destination device (for example a computer or patch panel). Ensure connectors are fully inserted until the latch clicks to confirm a secure mechanical and electrical connection. Route the cable to avoid sharp bends and sources of strong electromagnetic noise; when used in shielded installations, make sure grounding practices of the overall system are observed for optimal shielding performance.

Recommendations

For best results, use the cable for horizontal or patch connections up to 3 metres; avoid running it parallel and close to high-voltage power lines for extended distances. Inspect RJ-45 contacts periodically for dust or damage and replace the cable if connectors or jacket show wear that could affect performance.