Cable de red LogiLink C6A062S RJ-45 Cat6a 3 m gris

The LogiLink C6A062S RJ-45 Cat6a 3 m Grey is a shielded network patch cable engineered for stable, high-speed Ethernet connections. Built to Cat6a standard with S/FTP shielding and RJ-45 connectors on both ends, this 3-metre cable supports 10GBase-T transmissions and reduces electromagnetic and crosstalk interference. Its neutral grey jacket provides a discreet appearance suitable for visible runs in home and office environments.

Advantages

The S/FTP shielding construction delivers enhanced protection against external electromagnetic interference and pair-to-pair crosstalk, improving signal integrity over longer distances. Cat6a specification enables 10 Gigabit Ethernet performance where network infrastructure and devices support it. Standard RJ-45 connectors ensure broad compatibility with switches, routers, patch panels and network endpoints, while the 3 m length offers flexibility for desk-to-wall or rack-to-equipment connections without excess slack.

Suitable for

• 10G home or small office network connections
• Connecting desktops, laptops, switches and patch panels
• Wired streaming, online gaming and large file transfers
• Structured cabling where S/FTP shielding is required

Key specifications

• Cable category: Cat6a
• Shielding: S/FTP (overall foil with individually foil-shielded pairs)
• Supported standard: 10GBase-T
• Connector type: RJ-45 to RJ-45
• Length: 3 m
• Colour: Grey

How to use

Insert each RJ-45 connector into the corresponding network ports on your devices until the latch clicks. For optimal performance, avoid tight bends and kinks along the cable route and keep the cable separated from sources of strong electromagnetic interference such as large power supplies or fluorescent lighting. Ensure ports and devices support the required link speed; cables will operate at the highest mutually supported speed between connected equipment.

Recommendations

For best results in 10G networks, route the cable away from electrical mains cabling and maintain generous bend radii. Test links after installation with appropriate network testers if precise performance verification is required. Use the 3 m length to minimize excess slack while preserving accessibility for occasional device movement.