Cable de red LogiLink CQ6105S RJ-45 Cat6a 15 m negro

The LogiLink CQ6105S RJ-45 Cat6a 15 m Black networking cable is a 15-metre Ethernet cable built to the Cat6a standard. It supports data transfer rates up to 10000 Mbit/s and uses RJ-45 connectors on both ends. The cable features S/FTP shielding to reduce electromagnetic interference and maintain signal integrity over longer runs. Its black jacket provides a discrete, professional appearance suitable for office and home installations.

Advantages

The S/FTP shielding construction offers improved protection against external noise and crosstalk compared with unshielded cables, helping to sustain high throughput and stable connections. Compliance with the Cat6a standard enables higher bandwidth and supports 10 Gigabit Ethernet where network equipment and infrastructure allow. Ready-terminated RJ-45 connectors permit immediate plug-and-play connection without additional tooling. The 15 m length covers typical room-to-room and rack-to-workstation runs while the black outer jacket resists visible wear and integrates with most environments.

Suitable for

• 10 Gigabit Ethernet links within offices, server rooms and data closets
• Connecting switches, routers and patch panels to workstations and servers
• Home network backbones and high-speed media streaming setups
• Structured cabling where reduced interference is required

Key specifications

• Standard: Cat6a
• Maximum data rate: 10000 Mbit/s
• Shielding: S/FTP (overall braid with individually screened pairs)
• Connector type: RJ-45 to RJ-45
• Length: 15 m
• Colour: Black

How to use

Connect one RJ-45 end to the network device such as a router, switch or network interface on a computer and plug the other RJ-45 end into the corresponding port of the target device. Ensure connectors are fully inserted until the latch clicks. Avoid sharp bends, kinking or crushing of the cable along its run; maintain gentle radii around corners and route the cable away from sources of strong electromagnetic interference where possible.

Recommendations

For reliable 10 Gigabit performance, use the LogiLink Cat6a cable in combination with Cat6a-compliant network equipment and patch panels. When installing in permanent or high-density pathways, allow service loops and avoid bundling large numbers of cables tightly to minimize heat and crosstalk. Regularly inspect connector ends for damage or dirt and replace the cable if the jacket is compromised.