Cable de red LOGON SSTP Cat6a RJ-45 RJ-45 20 m marfil

The LOGON SSTP Cat6a RJ-45 to RJ-45 networking cable, 20 m in ivory, is designed for wired Ethernet connections that require Cat6a performance. It features four shielded twisted pairs (SSTP) with foil and full braid shielding, supports 100 Ohm impedance and uses 26/7 AWG conductors for reliable high-speed data transmission. Both ends have shielded RJ45 male connectors with boots providing kink protection and strain relief, wired 1:1 to the EIA/TIA 568B standard.

Advantages

Shielding on each pair plus an overall braid reduces electromagnetic interference and crosstalk, improving signal integrity for demanding network environments. The 26/7 stranded conductors balance flexibility and electrical performance for easier routing and durable connections. Molded boots with strain relief protect the connector entry and help prevent cable damage at frequent bend points.

Suitable for

• Gigabit and 10 Gigabit Ethernet within the Cat6a specification
• Office and home networking runs where reduced interference is required
• Patch panels, switches, routers and wall outlets with RJ45 ports

Key specifications

• Length: 20 m
• Cable type: SSTP Cat6a, 4 x 2 x AWG 26/7 twisted pairs
• Impedance: 100 Ohm
• Connectors: 2 x shielded RJ45 male
• Wiring: 1:1 — EIA/TIA 568B
• Colour: Ivory

How to use

Connect each RJ45 male connector to the corresponding RJ45 port on networking equipment such as a switch, router or wall outlet. Ensure connectors are fully inserted until the latch clicks. Route the cable without sharp bends and avoid running parallel to sources of strong electromagnetic interference to maintain optimal signal quality.

Recommendations

For best performance, use this Cat6a cable for short to medium permanent or patch runs up to 20 m, and pair it with shielded equipment or properly grounded patch panels to maximize EMI protection.