Cable de red LOGON TCU66U150M Cat6 U/UTP (UTP) 15 m magenta RJ-45–RJ-45

LOGON TCU66U150M Cat6 U/UTP (UTP) 15 m Magenta RJ-45–RJ-45 is a 15-metre Ethernet patch cable designed for internal wired networks. It meets Cat6 performance requirements and provides reliable Gigabit LAN connectivity between devices such as switches, routers, patch panels and wall outlets. The cable uses four twisted pairs and RJ-45 male connectors at both ends, with a magenta jacket for easy identification in structured cabling environments.

Advantages

The unshielded U/UTP design offers a balance of performance and flexibility for standard office and server room installations. Reinforced boots with kink protection and strain relief reduce connector stress and improve durability during repeated handling and routing. The magenta-coloured jacket simplifies cable management and tracing in dense installations, while plug-and-play RJ-45 terminations require no additional tools or configuration.

Suitable for

• Gigabit Ethernet connections between PCs, switches and routers
• Patch panels and wall outlet patching in offices and data closets
• Temporary and permanent horizontal cabling runs up to 15 metres
• Network identification and colour-coded cable management schemes

Key specifications

• Category: Cat6 performance
• Topology: U/UTP (unshielded twisted pair)
• Length: 15 m
• Conductor: 4 x 2 AWG 26/7, twisted pairs
• Characteristic impedance: 100 Ohm
• Connectors: RJ-45 male — both ends
• Connector features: boots with kink protection and strain relief
• Colour: magenta
• Installation: plug-and-play

How to use

Connect one RJ-45 end to the network device (switch, router, PC or patch panel) and the other end to the corresponding port. Ensure connectors are fully seated and that the boots are oriented to avoid excess bending near the connector. For best performance, avoid tight bends and maintain separation from high-voltage power cables where possible. The cable is ready to use without configuration for standard Gigabit Ethernet networks.

Recommendations

Route the cable following building cable management practices: use cable trays, ties or Velcro straps to prevent strain and maintain minimum bend radius. Use the magenta colour to match site labelling or to create distinct circuits for easier troubleshooting. For runs exceeding typical office pathways, verify patch panel and port labelling before connecting to ensure correct network topology.