Cable de red RJ45 Cat.6 U/UTP LSZH CCA 0,5 m — EFB Elektronik K8104SW.0

The unshielded Cat.6 RJ45 patch cable by EFB Elektronik provides reliable performance for 5 Gigabit Ethernet applications. It features a slim molded strain relief that eases connector insertion in tight spaces and a black LSZH jacket. The cable uses CCA (copper-clad aluminum) multicore conductors, supports frequencies up to 250 MHz and follows the Cat6 standard for structured cabling.

Advantages

The slim molded boot simplifies plugging in confined installations while the U/UTP (UTP) construction supports Cat6 performance up to 250 MHz. Gold-plated contacts improve connector durability and the LSZH (low smoke zero halogen) jacket reduces toxic emissions in case of fire. The 0.5 m length and male-to-male RJ45 connectors make it suitable for short patching runs.

Suitable for

Key specifications

How to use

Connect one RJ45 male end to the network port of your device and the other end to the corresponding port on the switch, patch panel or router. Ensure connectors are fully inserted until the latch clicks. Route the cable to avoid sharp bends and excessive tension, using cable guides or ties as needed. The slim molded boot helps when plugging into closely spaced ports.

Recommendations

For optimal performance, use this Cat6 U/UTP patch cable for short patch runs up to typical cabinet or desk distances. Avoid running the cable parallel and close to high-voltage power lines to minimize potential interference. Verify that CCA conductors meet your installation’s grounding and power-over-Ethernet (PoE) requirements before deployment.