Cable de red ShiverPeaks BS08-35482 amarillo 30 m Cat7 U/UTP

The ShiverPeaks BS08-35482 Yellow 30m Cat7 U/UTP networking cable is designed for high-speed wired connections in home, office, and data center environments. This 30-meter cable is constructed to Cat7 performance levels, providing support for multi-gigabit Ethernet and reliable data transmission. The cable uses U/UTP shielding and terminates in RJ-45 connectors with gold-plated contacts to maintain consistent signal integrity and corrosion resistance. Rated for data transfer rates up to 10000 Mbit/s, it is suitable for demanding network applications that require stable throughput over longer runs.

Advantages

The cable combines Category 7 performance with unshielded twisted pair construction under an overall foil shield (U/UTP), offering a balance between noise rejection and flexibility. Gold-plated RJ-45 connectors reduce contact resistance and improve long-term reliability in frequent plug/unplug scenarios. The 30 m length in a high-visibility yellow jacket simplifies cable management and identification in patching environments. Designed to meet modern network speed requirements, this cable supports high-bandwidth tasks while maintaining consistent electrical characteristics across its length.

Key specifications

• Cable category: Cat7 performance
• Length: 30 meters
• Cable construction: U/UTP (overall foil shield with unshielded twisted pairs)
• Connectors: RJ-45 with gold-plated contacts
• Maximum data rate: up to 10000 Mbit/s
• Color: yellow

How to use

Route the cable between network endpoints keeping bend radius recommendations in mind and avoiding tight kinks. Insert RJ-45 connectors firmly into compatible ports on routers, switches, network interface cards, or patch panels until the latch engages. For best performance, avoid running the cable in parallel with high-voltage power lines or sources of electromagnetic interference. If routing through conduits or cable trays, ensure the overall shield is intact and connectors are protected from mechanical strain.

Recommendations

For stable multi-gigabit performance, use the cable for direct device-to-switch connections and in structured cabling where a visible color aids identification. Test link performance after installation with a network tester to confirm proper termination and throughput.