Cable de red Telegärtner MP8 FS 100-2.0 negro 2 m Cat5e F/UTP

The Telegärtner MP8 FS 100-2.0 Black 2m Cat5e F/UTP is a 2-meter network patch cable designed for stable data transmission in small networks, office workstations and equipment interconnections. It complies with Cat5e performance parameters and uses F/UTP shielding to reduce electromagnetic interference, providing consistent throughput for Ethernet connections. The cable comes with factory-terminated RJ-45 connectors on both ends and a black outer jacket for a discreet professional appearance.

Advantages

F/UTP shielding combines an overall foil screen with individually unshielded pairs to suppress external interference while maintaining flexibility. The Cat5e standard supports Fast Ethernet and Gigabit Ethernet at typical installation lengths and offers reliable performance for typical office and home network use. Factory-terminated RJ-45 connectors ensure consistent contact and reduce installation time compared with on-site crimping. The 2 m length balances reach and cable management in desk and rack environments.

Suitable for (tasks / use cases)

• Connecting desktop PCs, printers and network-attached devices to switches or routers
• Patch connections in office patch panels and network cabinets
• Temporary or permanent workstation cabling where a 2 m length is appropriate
• Environments where reduced EMI is required, such as near power supplies or other cabling

Key specifications

• Standard: Category 5e (Cat5e) performance
• Shielding: F/UTP (overall foil shield, unshielded twisted pairs)
• Connector type: RJ-45 on both ends (factory-terminated)
• Length: 2 meters
• Color: Black outer jacket
• Nominal use: Ethernet networking (Fast/Gigabit where supported)

How to use

Insert each RJ-45 connector firmly into the Ethernet port of the devices to be connected until the latch clicks. Route the cable to avoid tight bends and sharp kinks; maintain bend radii recommended for structured cabling to preserve signal integrity. For patch panel or switch installations, label both ends if required for identification. Confirm link status via device LEDs or network diagnostics after connection to ensure proper operation.

Recommendations

Avoid running the cable in parallel with high-voltage power lines for long distances to minimize potential interference. For installations in high-interference environments, consider shielded connectors on both ends and grounding of the shield where applicable. Store excess length neatly with gentle loops and avoid excessive pulling force when routing through cable management.