Cable Ethernet ProXtend CAT6 RJ-45 10 m naranja

The ProXtend CAT6 F/UTP CU LSZH Ethernet Cable (10 m) with RJ-45 connectors uses 99.9% pure copper conductors (AWG 26) and a foil shield to provide stable Gigabit Ethernet performance. The outer LSZH jacket reduces smoke and toxic emissions in case of fire, and the cable supports PoE+. The orange cable has snagless strain-relief connectors with 50µ"U gold plating for improved contact durability and transmission quality.

Advantages

This CAT6 F/UTP CU cable combines solid copper conductors and foil screening to reduce interference and maintain reliable 10/100/1000Base-T(X) data transfer. The LSZH outer jacket improves safety in indoor environments, while the reinforced strain relief and snagless design simplify installation and reduce connector damage. 50µ"U gold-plated RJ-45 contacts offer higher durability and better signal transfer compared to standard metal plating.

Suitable for

• Wired Gigabit LAN connections (10/100/1000Base-T(X))
• PoE and PoE+ powered devices such as IP cameras and VoIP phones
• Office and data center patching where low-smoke cable is required
• Home networking and high-speed desktop connections

Key specifications

• Length: 10 m
• Conductor: 99.9% pure copper, AWG 26
• Shielding: F/UTP (foil screened pairs, unshielded overall)
• Connector: RJ-45 — both ends
• Plating: 50µ"U gold-plated contacts
• Standards: 10/100/1000Base-T(X)
• Jacket: LSZH (Low Smoke Zero Halogen)
• Color: Orange
• Supports: PoE+

How to use

Connect one RJ-45 end to your network device (switch, router or PC) and the other end to the corresponding port of the destination device. Ensure connectors are fully inserted until the latch clicks to guarantee proper contact. Route the cable to avoid sharp bends and excessive tension; use the reinforced strain relief and the snagless latch to protect the connector during installation.

Recommendations

For best performance, avoid running the cable parallel and close to high-voltage power lines or heavy electrical equipment to minimize electromagnetic interference. Use appropriate patch panels or keystone jacks for permanent installations and keep cable runs within recommended length limits for Gigabit Ethernet.