Cable SATA DeLOCK 85347 0,7 m

The DeLOCK 85347 SATA cable (0.7 m) connects internal SATA devices such as HDDs, SSDs, controller cards or flash modules. It uses two SATA 7-pin connectors and supports the SATA III standard with data transfer rates up to 6 Gb/s while remaining backward compatible with earlier SATA versions. The cable has a transparent black finish and is intended for internal PC use; when connected to a hard drive the cable will be routed downwards.

Advantages

The cable provides a stable SATA III connection supporting data rates up to 6 Gb/s and is backwards compatible with previous SATA versions. Metal clips on both SATA connectors secure the connection and ensure the cable clicks reliably into place. The 0.7 m length is suitable for typical internal PC routing and the transparent black design offers a discreet appearance inside the case.

Suitable for

• Connecting internal hard drives (HDD) and solid-state drives (SSD)
• Connecting SATA controller cards and add-in devices
• Replacing or extending existing internal SATA cable runs

Key specifications

• Cable length: 0.7 m
• Connectors: SATA 7-pin to SATA 7-pin
• Data transfer rate: up to 6 Gb/s (SATA III), backwards compatible
• Colour: transparent black
• Brand / MPN: DELOCK 85347

How to use

Route the cable inside the PC case from the motherboard or controller card SATA port to the SATA device. Align the 7-pin connector with the device's SATA socket and press until the metal clip engages for a secure connection; the cable is designed to sit downward when attached to a hard drive. Ensure both ends are fully inserted and locked before powering the system.

Recommendations

For optimal performance, use this SATA cable for internal connections only, avoid sharp bends or kinks, and keep cable runs away from sources of strong electromagnetic interference. If connecting older SATA devices, note that transfer speeds will be limited to the maximum supported by those devices.