Cable ShiverPeaks C19/C20 M/H 5 m negro conector hembra C20

The ShiverPeaks C19/C20 M/F 5m Black C20 coupler is a 5‑metre power connection cable designed to link equipment with C20 inlets to devices using C19 plugs. The cable supports a 16 A input current and is manufactured to meet relevant safety standards for reliable electrical connections. Its black jacket and robust connectors make it suitable for installs where a longer reach and durable coupling are required.

Advantages

This cable provides a consistent 16 A rated connection over a 5 m length, reducing the need for intermediate extensions. The C20 coupler and C19 plug combination ensures compatibility with a wide range of IT and professional power equipment. The construction emphasizes safety and durability through a standardized design that resists wear in active environments while maintaining stable electrical contact.

Suitable for

• Connecting servers, UPS systems and rack equipment with C20 inlets
• Linking power distribution units (PDUs) to devices with C19 plugs
• Temporary or semi-permanent power runs in data centres, workshops, and studios
• Situations requiring a 5 m reach without additional adapters or extensions

Key specifications

• Cable length: 5 metres
• Connector types: C19 plug to C20 coupler
• Rated current: 16 A
• Color: Black outer jacket
• Application category: Equipment power connection for IT and professional devices

How to use

Inspect the cable and connectors for visible damage before use. Align the C19 plug with the device inlet and insert fully until secure; connect the C20 coupler to the corresponding power source or PDU by lining up the coupler and engaging it until it seats. Ensure the connected equipment and supply are switched off while making connections. After installation, verify that the supply is stable and the load does not exceed the 16 A rating.

Recommendations

For safe operation, avoid sharp bends and sustained heavy mechanical stress on the cable. Use the cable in environments that comply with the specified temperature and ventilation requirements of connected equipment and replace the cable if any connector damage or insulation degradation is observed.