Cable XLR, PSSO de 3 pines, 3 m de longitud, conector Neutrik

PSSO 3-pin XLR cable, 3 m length, with Neutrik connectors is a balanced audio cable intended for microphone and line-level connections. The cable features Neutrik male and female terminations with secure locking, and a shielded balanced construction to reduce electromagnetic interference and preserve signal integrity over short to medium runs. It is suitable for live sound rigs, studio recording, broadcast chains and general audio patching where a dependable XLR connection is required.

Advantages

The cable offers a balanced three-conductor design that minimizes hum and noise by rejecting interference. Neutrik connectors provide reliable locking and low-contact resistance for secure physical and electrical connections. The 3 m length balances flexibility and reach for common stage and studio setups while keeping signal degradation and capacitance within practical limits. The shielded construction and robust connector strain relief improve durability under repeated use.

Suitable for

Key specifications

How to use

Connect the Neutrik male XLR plug to the input of the target device and the Neutrik female XLR socket to the output device, or vice versa depending on source and destination. Ensure connectors click into their locking positions to prevent accidental disconnection. Route the cable away from mains power cables and strong electromagnetic sources to reduce possible interference. For recording, verify polarity and phase alignment by checking signal levels and listening for expected mono-summed behaviour.

Recommendations

Use the 3 m length for close stage and studio connections where a compact, tidy cable run is preferred. Avoid sharp bends or kinks near the connector ends, and unplug by gripping the connector body rather than pulling the cable. Store coiled without tight loops and keep connectors capped or covered when not in use to extend service life.