CBO AOC SFP28 BlueOptics BO272703Q50M Cable óptico activo de 50m para puertos SFP28 de 25Gbps

CBO AOC SFP28 BlueOptics BO272703Q50M is a 50 meter active optical cable (AOC) factory-terminated for use with 25Gbps SFP28 ports. The single-cable design combines transceiver and fiber into one assembly, providing a direct-attach solution for high-speed server, switch and storage interconnects in data center environments. The cable supports 25 Gigabit Ethernet links and is intended for short- to mid-reach connections inside racks and across adjacent rows where a compact, low-latency link is preferred.

Advantages

The integrated transceiver and fiber assembly reduces the number of separate components and eliminates the need for separate transceivers and patch cords, simplifying installation and cable management. Active optical technology provides lower power consumption and reduced heat compared with some copper alternatives for equivalent data rates, while fiber optics enable stable signal integrity over the 50 m reach. The factory termination ensures consistent optical performance and minimizes field termination errors.

Suitable for

• 25GbE connections between servers and top-of-rack switches
• Interconnects between switches within data halls or adjacent racks
• High-performance storage networks and converged infrastructure
• Environments requiring compact cabling and reduced port adapter usage

Key specifications

• Form factor: SFP28 AOC (active optical cable)
• Maximum data rate: 25 Gbps per channel
• Cable length: 50 meters
• Connector type: SFP28 plug on each end (factory-terminated)
• Optical medium: multimode/mode-matched active optical assembly (factory-terminated)
• Typical use: short- to mid-reach data center interconnects

How to use

Install the AOC by inserting each SFP28 connector into the compatible 25Gbps SFP28 port on the devices to be linked; no additional transceivers or patch cords are required. Ensure ports are powered down or follow hot-plug guidelines from the equipment vendor where applicable. Verify link status and speed via host or switch management interfaces after connection. Avoid sharp bends and maintain appropriate cable routing to prevent mechanical stress and preserve optical performance.

Recommendations

Deploy this 50 m AOC in rack-to-rack or rack-to-switch scenarios where a factory-terminated, low-latency 25Gbps link is desired. Maintain bend radius and secure cable runs to avoid connector strain. Confirm compatibility with switch and server vendors' supported transceiver lists when necessary.