CBO AOC SFP28 BlueOptics BO272703Q7M cable óptico activo, SFP28, 7 m de longitud

The CBO AOC SFP28 BlueOptics BO272703Q7M active optical cable is a factory-terminated SFP28-to-SFP28 connection cable with a 7 m length designed for short-reach high-speed links. It supports 25GbE and other SFP28-compatible protocols to interconnect switches, servers and storage equipment in data centers and server rooms. The active optical design offers electrical isolation and reduced cable bulk compared to copper direct attach cables while maintaining low latency and high signal integrity for demanding networking environments.

Advantages

This BlueOptics SFP28 active optical cable delivers stable 25GbE performance with lower electromagnetic interference and improved thermal behavior relative to copper alternatives. The optical medium enables electrical isolation between devices and reduces weight and cable diameter, simplifying cable management in dense rack environments. Being a plug-and-play SFP28 solution, it requires no separate transceivers or fiber termination, which shortens installation time and minimizes points of failure.

Suitable for

• Short-reach 25GbE links between switches and top-of-rack devices
• Server-to-storage or server-to-switch interconnects in data centers
• High-density rack installations where reduced cable bulk is required
• Environments requiring electrical isolation to prevent ground loops

Key specifications

• Connector type: SFP28 to SFP28
• Length: 7 meters
• Supported data rate: designed for 25GbE and SFP28-compatible speeds
• Transmission medium: active optical cable (AOC)
• Typical benefits: low latency, electrical isolation, reduced cable diameter and weight

How to use

Install the cable by inserting each SFP28 connector into the corresponding SFP28 port on your compatible network devices until the latch engages. Verify link status through the device management interface and ensure firmware or port settings match the expected 25GbE operation. No additional transceivers or fiber termination are required; treat the cable gently and avoid sharp bends or excessive pulling to preserve optical performance.

Recommendations

For reliable operation, maintain bend radius recommendations provided by the manufacturer, keep connectors clean and capped when not in use, and use the cable in environments within the specified temperature and humidity ranges of your equipment. Confirm compatibility with your switch or server vendor documentation for SFP28 AOC support and, where possible, test the link after installation to validate performance.