Conector coaxial ShiverPeaks BS15-301514 8 uds.

The ShiverPeaks BS15-301514 coaxial connector pack contains eight connectors designed to provide reliable signal transmission for a range of RF and TV installations. The set pairs male IEC connectors with F-type connectors to enable straightforward coupling between devices and coaxial cables. Constructed for repeated connections and long-term use, these connectors suit both professional installers and domestic users working with aerials, set-top boxes, satellite equipment and cable TV systems.

Advantages

The connectors offer consistent electrical contact and minimal signal loss when properly installed, supporting clear reception and stable data transfer for TV and radio signals. Their robust mechanical design resists wear from repeated mating cycles and provides a firm fit to standard coaxial cable types. The pack of eight ensures enough parts for multi-room setups or for replacing worn connectors without frequent reordering.

Suitable for

• Connecting TV set-top boxes and televisions to wall outlets
• Linking satellite or cable receivers to coaxial cabling
• Short runs of RF distribution in residential installations
• Repairing or replacing damaged connectors on coax cables

Key specifications

• Quantity in pack: 8 pieces
• Connector types: male IEC and F-type
• Intended signal types: RF, television, cable and satellite signals
• Compatibility: standard 75 Ω coaxial cables and equipment
• Durability: engineered for repeated mating and secure mechanical fit

How to use

Prepare the coaxial cable by stripping the outer jacket, braid and dielectric to the recommended dimensions for the selected connector. Slide the connector body onto the cable, ensure the central conductor is correctly positioned for contact with the male pin, and secure the connector by crimping or tightening according to the connector design. After installation, check for a firm mechanical connection and verify signal quality on the connected device. Follow standard safety procedures including disconnecting equipment from power sources before working on cabling.

Recommendations

Use these connectors with properly prepared 75 Ω coaxial cables and compatible equipment to minimize signal loss. For best results, use appropriate tools (stripper, crimping tool or torque wrench where applicable) and test connections with a signal meter or by verifying picture/audio quality. Replace connectors that show corrosion, loose fit, or visible damage to maintain optimal signal integrity.