Conector coaxial tipo F ShiverPeaks BS15-300214

The ShiverPeaks BS15-300214 F-type coaxial connector pack contains four identical inline F-type connectors designed for use in audio and video signal paths. Each connector features F-type terminations on both ends to provide a straightforward, screw-on connection between coaxial cables or between a cable and equipment. The connectors are intended to support reliable signal transmission for home theater systems, cable television, satellite receivers and general AV cabling where standard F-type connections are required.

Advantages

These F-type connectors offer a compact inline form factor that simplifies joins between two coaxial cable segments or between cable and device port without the need for specialized tools. The threaded F-type ends provide secure mechanical contact and consistent electrical continuity, reducing the likelihood of signal loss or intermittent connection. Supplied as a set of four, the pack supports multiple connection points and small installation projects while maintaining compatibility with common coaxial cable types used in consumer AV and TV installations.

Suitable for

• Joining two coaxial cables with F-type terminations
• Connecting cable TV or satellite feeds to receivers and set-top boxes
• Extending or repairing connections in home theater and AV systems
• Temporary or permanent inline joins in residential installations

Key specifications

• Connector type: F-type inline connector with threaded terminations on both ends
• Pack quantity: 4 connectors
• Compatibility: standard 75 Ω coaxial cabling and consumer AV equipment
• Mechanical connection: screw-on F-type interface for secure contact
• Intended use: audio/video signal transmission for TV, satellite and home theater systems

How to use

To use the connector, align the threaded F-type end with the mating F-type jack on the cable or device and rotate clockwise until hand-tight. Ensure the cable center conductor seats properly in the connector to maintain electrical continuity and minimize signal reflection. For best results, inspect cable ends for clean cuts and correct stripping before joining. If removing the connector, rotate counterclockwise until disengaged.

Recommendations

For consistent signal quality, use these connectors with properly prepared 75 Ω coaxial cable and avoid over-tightening; hand-tight is typically sufficient. Place connectors in dry, protected locations and verify connections after installation to confirm satisfactory audio and video performance.