Conector hembra Keystone RJ45 ShiverPeaks CAT6A STP, 2 uds.

Keystone RJ45 Connector ShiverPeaks CAT6A STP, 2 pieces is a pair of shielded keystone jacks designed for terminating shielded twisted-pair Ethernet cables to support CAT6A performance. These keystone connectors are compatible with standard keystone wall plates and patch panels, allowing easy mounting in residential, office, and data-center environments. The STP design provides an integrated metal shield to reduce electromagnetic interference and maintain signal integrity for high-speed networks up to 10 Gbps when properly installed.

Advantages

The shielded construction of these CAT6A keystone connectors minimizes crosstalk and external electromagnetic interference, improving reliability for high-bandwidth applications. Supplied as a convenient 2-piece pack, they enable quick replacement or installation of multiple ports without purchasing individual units. The keystone form factor ensures compatibility with a wide range of faceplates and patch panels, and the connectors are engineered to meet the mechanical and electrical requirements common to CAT6A terminations.

Suitable for

• Terminating STP/CAT6A Ethernet cables in wall plates and patch panels
• Residential and home office network upgrades requiring reduced interference
• Office networks and structured cabling supporting 10 Gigabit Ethernet
• Data-center areas where shielded connections are preferred for signal integrity

Key specifications

• Category: CAT6A (augmented) performance for frequencies up to 500 MHz
• Shielding: STP (shielded twisted pair) with integrated metal housing
• Form factor: Keystone jack compatible with standard keystone openings
• Contact type: 8P8C (RJ45) modular contacts suitable for stranded or solid conductors where applicable
• Quantity: Pack of 2 connectors
• Intended data rates: Suitable for 10 Gbps Ethernet when installed per CAT6A guidelines

How to use

Prepare the shielded Ethernet cable by removing the outer jacket and carefully exposing the foil drain and twisted pairs according to the connector's termination instructions. Maintain the cable shield continuity by bonding the cable drain or shield to the connector’s metal housing as specified, then insert conductors into the appropriate termination slots and perform the punch-down or IDC termination method provided by the connector design. Once terminated, snap the keystone connector into the desired wall plate or patch panel opening and verify continuity and performance with appropriate network test equipment.

Recommendations

For optimal CAT6A/STP performance, ensure the cable shielding is properly terminated and that connectors are installed in compatible shielded faceplates or panels. Avoid sharp bends and excessive untwisting of pairs; test each link after installation to confirm 10 Gbps capability and correct shielding continuity.