Conector RJ45 Cat6A plano ShiverPeaks BS75004

The ShiverPeaks Flat Cat6A RJ45 Connector BS75004 is a single-piece RJ45 connector engineered for high-speed data transmission and reliable network terminations. Its flat construction and stainless steel finish offer a low-profile appearance suitable for space-constrained installations and visible cabling runs. Designed for Cat6A cabling, the connector supports performance requirements of modern Ethernet networks while remaining simple to install and use.

Advantages

The flat design reduces strain and bulk at cable terminations and improves compatibility with slim cable management channels. A stainless-steel colored exterior provides a corrosion-resistant look that integrates with metal or neutral-toned equipment. As a single-piece connector, it eliminates the need for additional housing parts, simplifying termination and reducing the number of components required for straightforward network repairs or expansions.

Suitable for

• High-speed Ethernet installations using Cat6A cable
• Tight spaces and shallow cable ducts where low-profile connectors are needed
• Home and small office wired networking
• Patch panels, wall plates and custom cabling projects

Key specifications

• Connector type: RJ45
• Cable category compatibility: Cat6A
• Construction: Flat, single-piece design
• Finish: Stainless steel color
• Sold quantity: 1 piece

How to use

Prepare the Cat6A cable by stripping the outer jacket and arranging the twisted pairs according to the required wiring standard. Insert the wires into the connector evenly and ensure full contact with the internal contacts; then complete termination following a compatible crimping tool procedure. After crimping, verify the connection with a network tester to ensure continuity and correct pair mapping. The flat connector design permits placement in confined spaces and direct mounting to compatible faceplates or patch cords.

Recommendations

Use a crimping tool rated for Cat6A/RJ45 terminations and perform continuity and performance checks after installation. Avoid excessive bending at the termination point and secure cabling with appropriate strain relief to maintain signal integrity.