Creality Ender-3 V3 SE Kit de termistor (4004070032)

Replace a faulty hotend temperature sensor on your Creality Ender-3 V3 SE 3D printer with this thermistor kit. It restores accurate temperature readings so you can resume printing without thermal runaway errors or failed prints.

Key specifications

• Thermistor type: NTC 100K
• Resistance at 25°C: 100 kOhm
• Maximum operating temperature: 260°C
• Cable length: 100 mm
• Connector type: XH2.54 2-pin
• Sensor type: Glass bead thermistor
• Installation method: Insert into heater block
• Material: High-temperature resistant wiring, glass bead sensor
• Compatibility: Creality Ender-3 V3 SE

Why choose it

This kit includes the thermistor and cable assembly, ready to install. The NTC 100K sensor provides high precision for stable temperature control, and the glass bead design withstands the heat of the hotend.

Ideal use cases

• Replacing a damaged or worn thermistor on the Ender-3 V3 SE
• Restoring accurate hotend temperature measurement
• Preventing thermal runaway and print failures

Good to know

The thermistor is inserted into the heater block and secured. The 2-pin XH2.54 connector plugs directly into the printer's mainboard. Ensure the printer is powered off before installation.