Desbarbador para tubo rígido XSPC PETG – herramienta de desbarbado para tubos de PETG/acrílico

XSPC PETG Hardtube Entgrater is a handheld deburring tool created for finishing PETG and similar rigid acrylic cooling tubes used in PC liquid-cooling systems. The tool trims and smooths rough or uneven cut edges to improve the seating of fittings and the reliability of seals, reducing the risk of leaks and uneven connections. It is compact and designed for manual use by DIY builders and technicians working with hard tubing.

Advantages

The deburring tool produces a clean, consistent edge on PETG tubing without requiring complex setup or power tools. Its handheld form factor offers control for precise trimming and reaming of the inner and outer tube edges. By removing burrs and sharp fragments, it helps achieve better fitting alignment and longer-lasting seals in coolant loops, reducing the need for repeated adjustments.

Suitable for

• Finishing PETG hard tubing after cutting
• Preparing tube ends for compression fittings and adapters
• Routine maintenance and refurbishment of PC water-cooling loops
• Small-scale workshop and DIY liquid-cooling projects

Key specifications

• Material compatibility: PETG and similar rigid acrylic tubing
• Tool type: handheld manual deburring and reaming tool
• Primary function: remove burrs and smooth inner and outer cut edges
• Application area: hard tubing for PC liquid-cooling systems
• Operation: manual control for precision trimming

How to use

Secure the cut piece of PETG tubing and ensure the end is free from loose fragments. Insert the tube into the entgrater and apply steady, even pressure while rotating the tool or the tube to ream the inner bore and chamfer the outer edge. Continue until the edge is smooth and even; inspect visually and by feel to confirm there are no remaining burrs. Clean the tube end of any debris before installing fittings or performing a leak test.

Recommendations

Use gentle, consistent motions and avoid excessive force to prevent cracking or deforming PETG tubing. Work in a well-lit area and wear eye protection when removing burrs. After deburring, dry-fit fittings to check alignment before fully assembling the cooling loop and performing a pressure or leak test.