Distribuidor de agua EK Water Blocks EK-Loop OmniLink 2-Way 100mm — distribuidor de refrigeración líquida de 2 vías, 100 mm de separación

EK Water Blocks EK-Loop OmniLink 2-Way 100mm is a two-way liquid cooling splitter created for custom PC water-cooling loops. With a 100 mm center-to-center spacing between ports, this splitter provides two outlet ports that allow routing coolant into separate branches or components. It is intended to simplify tubing runs and to provide a compact, organized junction for distributing coolant to radiators, GPU or CPU blocks, reservoirs and other loop elements.

Advantages

The EK-Loop OmniLink 2-Way 100mm offers a compact and rigid distribution point that reduces the need for multiple fittings and angled adapters. Its fixed 100 mm spacing aligns with common mounting or tubing layouts, enabling cleaner tubing runs and easier maintenance. The two-port design permits parallel or sequential routing depending on loop requirements, helping to balance tubing lengths and minimize clutter inside the chassis.

Suitable for

• Splitting coolant flow to two radiators or two component blocks
• Branching a main loop to a secondary loop or reservoir
• Organizing tubing runs in compact cases where fixed spacing helps alignment
• Custom liquid cooling systems for gaming or workstation PCs

Key specifications

• Two outlet ports for coolant distribution
• 100 mm spacing between port centers
• Designed for use in custom PC water-cooling loops
• Compatible with standard liquid cooling fittings and tubing of matching size
• Compact form factor for mounting or in-line placement inside a chassis

How to use

Install the EK-Loop OmniLink 2-Way 100mm inline with your loop by connecting the inlet and two outlets using compatible fittings and tubing. Ensure fittings are tightened to manufacturer torque recommendations and that tubing is cut squarely for secure seals. Route the two outlet lines to the intended components or radiators, keeping tubing lengths and bends to a minimum for optimal flow. After installation, perform a leak test with the system powered off and the pump running to verify all connections are watertight before powering the PC.

Recommendations

Use fittings and tubing sizes that match the splitter’s ports and follow standard leak-testing procedures. When planning the loop, position the splitter where its 100 mm spacing best aligns with component locations to reduce the number of angled adapters. Regularly inspect connections and replace tubing or seals showing wear to maintain reliable operation.