Extensor PoE PULSAR EXT-POE4H 48V – extensor para 2 cámaras IP

The PULSAR PoE Extender EXT-POE4H 48V is a hermetically sealed Power over Ethernet extender designed to supply stable 48V power to up to two IP cameras. Built for outdoor and harsh environments, this extender eliminates the need for separate power lines by extending PoE reach while protecting electronics from moisture, dust and temperature fluctuations. The device supports common CCTV deployments where reliable remote powering and environmental protection are essential.

Advantages

The hermetic casing provides IP-grade protection against moisture and dust, increasing longevity in outdoor installations. Dual-outlet PoE power delivery enables powering of two IP cameras from a single network feed, reducing cabling complexity. The extender maintains stable 48V output to ensure consistent camera operation and simplifies installation by avoiding separate power supplies at camera locations.

Suitable for

Key specifications

How to use

Connect the network cable carrying PoE from the switch or PoE injector to the extender's input port. Route the two output cables from the extender to the respective IP cameras. Ensure connectors and cable entries are fully sealed according to the installer instructions to preserve the hermetic integrity. Power and data are extended over standard Ethernet cabling; no additional local power sources are required at the camera endpoints when using compatible PoE cameras.

Recommendations

Install the extender in a location that minimizes exposure to direct water drips and mechanical impact. Use outdoor-rated Ethernet cables and maintain proper cable length and quality to preserve signal and power delivery. Verify camera power requirements are compatible with 48V PoE output and test the system after installation to confirm stable operation of both cameras.