FlashForge Guider 3 / Guider 3 Plus cable del sensor del eje Z (40001946002)

The FlashForge Guider 3 / Guider 3 Plus Z-Axis Sensor Cable is an original replacement part designed to connect the Z-axis limit switch or sensor to the mainboard of your 3D printer. This cable ensures accurate Z-axis homing and limit detection, critical for precise print layer alignment and reliable operation.

Advantages

This genuine FlashForge cable guarantees a perfect fit and reliable performance. It is a plug-and-play replacement, making installation quick and easy. The cable is built with high-quality copper wire and PVC insulation for durability and consistent signal transmission.

Suitable for

• FlashForge Guider 3 3D Printer
• FlashForge Guider 3 Plus 3D Printer

Key specifications

• Product Type: Z-Axis Sensor Cable
• Compatibility: FlashForge Guider 3, Guider 3 Plus
• Connector Type (Mainboard End): JST-XH 3-Pin
• Connector Type (Sensor End): JST-XH 3-Pin
• Number of Pins: 3
• Cable Length: 400 mm
• Material: Copper Wire, PVC Insulation
• Color: Multi-colored wires
• Operating Temperature: -20°C to 80°C
• Original Part: Yes (FlashForge Original)
• Installation: Plug-and-Play

Recommendations

For optimal performance, always use genuine FlashForge replacement parts. This Z-axis sensor cable is essential for maintaining the accuracy and reliability of your Guider 3 or Guider 3 Plus printer. If you experience Z-axis homing issues, replacing this cable is a recommended first step.