FlashForge Guider IIs Motor paso a paso del eje X (20001061001)

When the X-axis motion on your FlashForge Guider IIs 3D printer becomes unreliable, this replacement stepper motor restores precise carriage movement. It is a direct fit for the Guider IIs, matching the original motor's NEMA 17 form factor and electrical characteristics.

Key specifications

• Motor type: 2-phase stepper motor
• Frame size: NEMA 17
• Step angle: 1.8 degrees
• Rated voltage: 2.8 V
• Rated current: 1.7 A
• Holding torque: 0.4 Nm (40 N.cm)
• Shaft diameter: 5 mm, D-cut
• Connector: JST-XH 4-pin
• Mounting hole spacing: 31 mm

Why choose it

This motor is specified for the X-axis of the FlashForge Guider IIs, ensuring correct torque and speed for smooth, accurate prints. Its D-cut shaft and JST-XH connector allow for straightforward installation without soldering or firmware changes.

Ideal use cases

• Replacing a failed or noisy X-axis motor on a FlashForge Guider IIs
• Keeping a spare motor on hand for maintenance in print farms or educational labs

Good to know

The motor is built with a steel and copper construction for durability. It is a direct replacement part, not a generic upgrade, so it matches the printer's original motion system.