G.Skill | Ripjaws | 16 GB | DDR4 | 3200 MHz | Portátil | Registered No | ECC No

G.SKILL Ripjaws DDR4 SO-DIMM 16GB (3200 MHz) is a notebook memory module designed to upgrade laptops and small form factor PCs. This DDR4 SO-DIMM module provides higher data transfer rates and improved energy efficiency compared with previous generations, and supports Intel XMP 2.0 profiles for simplified performance tuning.

Advantages

The module operates at 3200 MHz and uses low-voltage DDR4 operation (1.2 V), reducing power consumption and heat output while maintaining stable performance. Components are selected through G.SKILL's screening process and each kit is tested to ensure reliability. XMP 2.0 support allows easy activation of optimized memory timings and frequency.

Suitable for

• Upgrading gaming notebooks that accept DDR4 SO-DIMM modules
• Small form factor PCs and mini‑PCs with DDR4 SO-DIMM slots
• Multitasking and productivity workloads on laptops
• Users seeking a straightforward XMP-enabled memory upgrade

Key specifications

• Capacity: 16 GB
• Memory type: DDR4 SO-DIMM
• Speed: 3200 MHz
• Voltage: 1.2 V (DDR4 standard)
• Error correction: Non-ECC
• Model/MPN: F4-3200C22S-16GRS
• EAN: 4713294226648

How to use

Power off the laptop or mini‑PC and disconnect it from power. Open the memory compartment or remove the bottom cover according to the device manual. Align the DDR4 SO-DIMM module with the slot notch and insert at a slight angle, then press down until the module clicks into place and the retention clips engage. Reassemble the device, reconnect power and boot. To enable XMP 2.0 profiles, enter the system BIOS/UEFI and select the appropriate memory profile if available.

Recommendations

Install modules in matching pairs where the system supports dual-channel operation for best memory bandwidth. Verify device compatibility with DDR4 SO-DIMM 3200 MHz modules and consult the laptop or motherboard manual before installation.