go-e Gemini flex 2.0 Negro Blanco Wallbox 11000W Type 2

The go-e Charger Gemini flex 2.0 11 kW is a smart wallbox with an integrated SIM card and a maximum charging capacity of 11 kW for charging battery electric vehicles and plug-in hybrids indoors or outdoors. The compact unit supports Type 2 connection and can be connected to a red CEE 16 A three-phase socket for plug & play operation. Cellular connectivity enables remote access, diagnostics and smart charging functions even without a Wi‑Fi network; over-the-air updates are supported. The device must not be opened and is not permitted for use in Norway.

Advantages

The wallbox provides mobile connectivity (4G LTE Cat‑1 with 2G fallback) so intelligent functions such as PV surplus charging, scheduled charging and tariff-based charging work outside Wi‑Fi range. Built‑in DC residual current protection switches the charger off in case of DC leakage, improving safety. The free go‑e app allows configuration of basic and convenience settings and enables remote support and troubleshooting via the integrated cellular connection. The unit can be converted quickly into a mobile charger and is suitable for indoor and outdoor installation.

Suitable for

• Home garage and carport charging of electric cars and plug‑in hybrids
• Temporary or mobile charging when connected to a CEE 16 A three‑phase socket
• Installations where Wi‑Fi is unavailable but cellular coverage exists

Key specifications

• Model: go‑e Charger Gemini flex 2.0 (Black/White)
• Maximum charging power: 11 kW (11000 W)
• Connector type: Type 2
• Connection: Plug into red CEE 16 A three‑phase socket (plug & play)
• Cable length: 0.3 m (fixed cable section / adapter as supplied)
• Network: Integrated SIM (4G LTE Cat‑1, fallback 2G/Edge), Wi‑Fi support
• Safety: DC residual current protection module
• Origin: Austria
• Restrictions: Not for use in Norway

How to use

Mount the wallbox indoors or outdoors following local installation rules and connect it to a suitable red CEE 16 A three‑phase socket; no internal access or opening of the device is required. Plug the vehicle into the Type 2 socket, start charging via the vehicle or the go‑e app and, if desired, set charge schedules, PV surplus charging or tariff preferences through the app. Use the integrated cellular connection for remote access and allow over‑the‑air updates for diagnostics and firmware maintenance.

Recommendations

The charger should be installed by a qualified electrician and used with compatible electric vehicles supporting Type 2 connection. Ensure adequate cellular coverage for remote functions and keep the device closed—do not open the enclosure. Observe national regulations and the restriction that the product must not be used in Norway.