Alcasa S1 IC01-24F01 LC negro 3 m conector recto

The Alcasa S1 IC01-24F01 LC Black 3m Straight Connector is a 3-meter fiber optic patch cable with LC connectors in a straight form factor and black jacket. Designed for standard single- and multi-fiber patching in network racks, distribution frames and active equipment, this cable provides a compact LC termination that suits high-density environments and typical data, voice and video transport applications.

Advantages

The LC termination offers a small footprint connector that helps save port space while maintaining reliable optical performance. A 3 meter length balances flexibility and tidy routing within racks or between adjacent cabinets. The straight connector design ensures a consistent mating interface with LC ports and transceivers. The black outer jacket provides a neutral appearance and basic protection against abrasion and handling during installation.

Suitable for

• Patch connections between switches, patch panels and transceivers
• Data center horizontal and equipment-side patching
• Telecom and structured cabling backbones where LC terminations are used
• Audio/video distribution systems requiring fiber interconnects

Key specifications

• Connector type: LC to LC (straight)
• Cable length: 3 m
• Jacket color: black
• Cable use: fiber optic patch cable for network interconnects
• Suitable density: compact LC form factor for high-density panels

How to use

Inspect connectors for dust or damage prior to installation and, if necessary, clean end faces with appropriate fiber cleaning tools. Route the 3 m cable between devices ensuring no sharp bends or excessive tension; maintain the manufacturer-recommended minimum bend radius for fiber cables. Insert the LC connectors into the corresponding LC ports on patch panels, switches or transceivers until a positive latch is felt. Confirm link status on connected equipment and, if required, test optical insertion loss with suitable fiber test equipment.

Recommendations

Store unused cable neatly on reels or in trays to avoid kinks. Use protective dust caps when connectors are not mated. For best optical performance, keep connector end faces clean and avoid tight bends; replace if physical damage is observed.