Transceptor SFP+ HP Enterprise X130 10G LC LR (JD094B-RFB) 10 Gigabit, conector LC, alcance LR

HP Enterprise X130 SFP+ transceiver JD094B-RFB is a 10 Gigabit optical module with an LC duplex connector and LR (Long Reach) optical specification. Designed for compatible switches and servers, this SFP+ transceiver provides single-mode fiber connectivity for long-distance 10G links in data centers, campus backbones and enterprise point-to-point connections. The module is intended to meet standard SFP+ electrical and optical interfaces while maintaining compatibility with HP Enterprise equipment that accepts the JD094B-RFB part.

Advantages

The HP Enterprise X130 10G LC LR transceiver delivers 10 Gigabit data rates over single-mode fiber with LR reach, enabling extended link distances without intermediate regeneration. The LC duplex connector provides a compact and widely supported optical interface. Built to industry SFP+ form-factor specifications, the module is suitable for hot-plug installation and integrates with standard 10G ports on compatible network devices. Its OEM part number (JD094B-RFB) and HP Enterprise branding indicate intended interoperability with HP Enterprise hardware.

Suitable for

• 10G single-mode fiber uplinks between switches and routers
• Long-reach connections in campus and metropolitan area networks
• 10G links between data center racks or buildings
• High-capacity server-to-switch connections requiring LC duplex interfaces

Key specifications

• Brand: HP Enterprise
• Model / MPN: JD094B-RFB (X130)
• Data rate: 10 Gigabit (10G)
• Connector: LC duplex
• Optical reach: LR (Long Reach) specification
• Form factor: SFP+
• EAN: 5706998672025
• Category: Network transceiver module

How to use

Install the SFP+ transceiver into a compatible 10G SFP+ port on an HP Enterprise switch or server, ensuring the device supports the JD094B-RFB part or generic SFP+ LR modules. After inserting the module, connect LC duplex single-mode fiber optic cables to the TX and RX ports, observing proper polarity. Configure the network device port for 10G operation if required by the operating system or switch firmware. Monitor link status indicators and device logs to confirm successful negotiation and optical link integrity.

Recommendations

Use single-mode fiber with appropriate LC duplex connectors and maintain correct polarity. Verify compatibility with the host device firmware and follow standard electrostatic discharge (ESD) precautions when handling the transceiver. For long-distance links, check optical budget and attenuation of the fiber path to ensure LR reach requirements are met.