InLine Cable de red SF/UTP Cat.5e azul 0,3m

The InLine Patch Cable SF/UTP Cat.5e blue 0.3m is a 0.3 m Category 5e twisted-pair network cable with RJ-45 connectors on both ends. It supports Gigabit Ethernet (1 Gbit/s) at frequencies up to 125 MHz and uses SF/UTP shielding to reduce electromagnetic interference. The cable is intended for connecting network components such as switches, routers, wall sockets, patch panels and network cards in home and office environments.

Advantages

SF/UTP shielding provides improved protection against external interference compared with unshielded cables, while Cat.5e specification and 10/100/1000Base-T(X) compatibility allow stable data transfer at up to 1 Gbit/s. The 0.3 m length is suitable for short patching runs in racks or desktop setups, and the blue jacket enables easy visual identification in multi-cable installations.

Suitable for

• Short connections between patch panels and switches
• Desktop connections to routers or network cards
• Patching within server racks and network cabinets

Key specifications

• Cable type: Cat.5e twisted pair (SF/UTP)
• Length: 0.3 m
• Connectors: RJ-45 — both ends
• Data rate: up to 1000 Mbit/s (1 Gbit/s)
• Frequency: up to 125 MHz
• Cabling technology: 10/100/1000Base-T(X)
• Colour: Blue

How to use

Insert the RJ-45 connectors into the corresponding ports on the devices to be connected (for example, switch to patch panel or router to network card) until the connector latch clicks. Ensure both ends are fully seated and avoid sharp bends or kinks in the cable to maintain signal integrity. For installations in racks or cabinets, route the cable alongside other patch cords to keep the layout tidy and minimise stress on the connectors.

Recommendations

Use this 0.3 m SF/UTP Cat.5e cable for short patching tasks where shielding is required to limit interference; avoid running the cable parallel to mains power lines over long distances and keep bend radius above manufacturer-recommended limits to preserve performance.