Kingston Technology FURY 64GB 5600MT/s DDR5 CL40 SODIMM (Kit de 2) Impact PnP

Kingston FURY Impact DDR5 SO-DIMM 64GB (2 x 32GB) at 5600MT/s brings DDR5 performance to laptops and small-form-factor systems. This Intel® XMP 3.0 Certified kit uses a 262-pin SO-DIMM form factor and offers a compact, low-power memory upgrade with on-die ECC for improved stability during high-speed operation. Modules with Plug N Play automatically reach their listed top speed, while XMP 3.0 profiles enable manual selection of the highest supported frequency in BIOS.

Advantages

The Kingston FURY DDR5 SO-DIMM delivers higher base speeds (starting at 4800MT/s) and improved bandwidth compared with DDR4, supporting demanding multitasking, gaming and rendering tasks. Plug N Play modules provide automatic overclocking to the module’s rated speed without user configuration, while XMP 3.0 certified profiles allow precise, pre-optimised timing, speed and voltage settings for further overclocking. Low operating voltage helps reduce power consumption and heat, and on-die ECC increases data integrity during high-frequency operation.

Suitable for

• Upgrading laptops to higher memory capacity (64GB) for heavy multitasking
• Portable workstations and small-form-factor PCs requiring SO-DIMM DDR5 memory
• Gaming laptops and mobile content-creation systems needing higher bandwidth

Key specifications

• Capacity: 64 GB (2 x 32 GB)
• Memory type: DDR5 SO-DIMM (262-pin)
• Rated speed: 5600 MT/s (starting DDR5 base 4800 MT/s)
• CAS Latency: CL40
• Memory clock: 2800 MHz (effective 5600 MT/s)
• Voltage: 1.1 V
• On-die ECC: yes
• Certification: Intel® XMP 3.0 Certified
• MPN: KF556S40IBK2-64
• EAN: 0740617331646

How to use

Power off the laptop or small-form-factor PC and disconnect from mains. Open the system’s memory access panel following the manufacturer’s instructions, then remove existing SO-DIMM modules if required. Align the notch of each Kingston FURY DDR5 SO-DIMM with the slot and press down evenly until the retaining clips engage. Reassemble the device and power it on. For automatic overclocking, ensure Plug N Play functionality is enabled by default; to enable maximum XMP 3.0 speeds, enter BIOS/UEFI and select the appropriate XMP profile.

Recommendations

Install modules in matched pairs and consult your laptop or motherboard documentation for supported maximum memory capacity and compatible DDR5 SO-DIMM speeds. If you rely on the highest XMP frequencies, verify BIOS support for Intel® XMP 3.0 and follow system vendor guidance to maintain system stability.