Kingston ValueRAM - DDR5 - módulo - 32 GB - SO DIMM 262-PIN

KINGSTON ValueRAM 32 GB DDR5 6400 MT/s 262-pin SO-DIMM 1.1 V is a single 32 GB memory module designed to expand system memory in compatible laptops and small form-factor systems. This DDR5 SO-DIMM operates at 6400 MT/s with CAS latency 52 and a low operating voltage of 1.1 V, providing higher data throughput and improved power efficiency compared with previous-generation modules. The module follows the 262-pin SO-DIMM form factor and is intended for straightforward memory upgrades to support heavier multitasking and memory‑intensive applications.

Advantages

The module delivers higher bandwidth through DDR5 technology at 6400 MT/s while maintaining power efficiency at 1.1 V, which helps reduce overall system power draw. With a full 32 GB capacity in a single SO-DIMM stick, it simplifies upgrades by eliminating the need to populate multiple slots. The component’s standardized form factor and established compatibility profile make it suitable for many modern laptops that accept 262-pin DDR5 SO-DIMM memory.

Suitable for

• Upgrading laptop memory for improved multitasking
• Replacing or expanding SO-DIMM slots in small form-factor PCs supporting DDR5
• Running virtual machines or memory-intensive productivity software
• Use in content creation workflows that require larger memory capacity

Key specifications

• Capacity: 32 GB
• Memory type: DDR5
• Speed: 6400 MT/s
• Form factor: 262-pin SO-DIMM
• CAS latency: 52
• Voltage: 1.1 V

How to use

Ensure the target laptop or small form‑factor system supports DDR5 262-pin SO-DIMM modules and the specified memory speed. Power down the device, disconnect power and remove the battery if applicable. Access the memory compartment according to the manufacturer’s service instructions, align the module with the SO-DIMM slot notch, insert at an angle and press gently until the retention clips engage. Reassemble the device, reconnect power, and verify system recognition of the new memory in BIOS/UEFI or the operating system.

Recommendations

For optimal results, install the module in accordance with the system vendor’s memory configuration guidelines; when possible, match capacity and speed across modules to enable balanced performance. Update the system BIOS/UEFI if required and run a memory test after installation to confirm stability.