Kit de cable para disco duro interno HP Z2 TWR G1i — conjunto de cables para conectar discos duros internos

HP Z2 TWR G1i HDD cable kit is a factory accessory designed to provide the cable assembly required to connect internal hard drives in HP Z2 tower workstations. The kit supplies the compatible cabling needed to link 2.5" or 3.5" SATA drives to the system board or drive backplane, supporting service, upgrades and component replacement tasks. It is intended for use when restoring drive connectivity or installing additional storage in the workstation chassis.

Advantages

The cable assembly is manufactured to HP factory specifications to ensure reliable physical and signal connections with HP Z2 tower components, reducing compatibility issues and installation errors. Using the original-style kit helps maintain tidy internal routing and minimizes installation time for technicians by providing the correct connectors and cable lengths for the chassis. The cables are intended to meet required mechanical and electrical fit for a consistent result during upgrades or repairs.

Suitable for

• Replacing a damaged or missing internal HDD/SATA cable in HP Z2 tower workstations
• Installing additional 2.5" or 3.5" SATA hard drives or SSDs in the system
• Service and maintenance tasks performed by technicians or IT support teams
• Upgrading storage while preserving original cable routing and connectors

Key specifications

• Compatibility: designed for HP Z2 tower workstation chassis (G1 generation)
• Connector types: internal SATA data and power-compatible assembly intended for standard drive interfaces
• Cable configuration: factory cable assembly with appropriate connector pitch and length for internal routing in the workstation
• Use case: supports SATA hard drives and SATA-based SSDs mounted in internal bays

How to use

Power down the workstation and disconnect external power before beginning. Open the chassis following HP service instructions, position the drive in the appropriate bay, and attach the cable assembly to the drive and the corresponding system board or backplane connector. Ensure connectors are firmly seated and routed to avoid contact with cooling fans or sharp edges. Close the chassis, reconnect power and power on the system to verify drive detection in BIOS or the operating system.

Recommendations

Handle connectors by their molded housings and avoid pulling on individual wires. Use anti-static precautions when working inside the workstation. If drive detection fails after installation, recheck connector seating and cable routing, and consult HP service documentation for diagnostic steps.