Llave combinada Gedore 6003180

The Gedore 6003180 combination wrench is a chrome-plated hand tool made from Gedore vanadium steel (31CrV3). It follows DIN 3113 Form B, ISO 3318 and ISO 7738 standards where applicable, with a ring offset of 10° from the shaft. The wrench has thin-walled but extra-strong ring ends and is built for repeated fastening and loosening of nuts and bolts. The tool measures 63 mm in depth, 38 mm in height and weighs 672 g.

Advantages

The 10° ring offset improves access in confined spaces while the thin-wall yet reinforced ring design allows good contact with fasteners without excessive bulk. Chrome plating increases corrosion resistance and simplifies cleaning. Construction from Gedore vanadium steel (31CrV3) provides strength and durability for frequent workshop use. Note: certain sizes (marked with an asterisk in manufacturer data) are not standardised.

Suitable for

Key specifications

How to use

Select the correct size of the Gedore 6003180 combination wrench for the fastener. Engage the box end over the nut or bolt head with the ring offset oriented to improve access. For greater leverage, apply force to the open-end or box-end as appropriate and avoid sudden impacts. After use, wipe the wrench clean and store it in a tool rack or toolbox to prevent corrosion and damage.

Recommendations

The tool is intended for manual use on nuts and bolts within its rated size range. Do not use the wrench with power tools, as this may damage the thin-wall ring or the chrome finish. For stubborn fasteners, use controlled force or appropriate penetrating lubricant rather than extending the handle with pipes or cheater bars.