Microconnect B-UTP615 Cable de red gris 15 m Cat6 U/UTP (UTP)

The Microconnect B-UTP615 RJ-45 Cat6 15 m Grey is a U/UTP Cat6 networking cable designed to deliver stable, high-speed wired connections for home and office networks. With RJ-45 connectors on both ends and a 15 m length, it connects switches, routers, network cards and other Ethernet devices while supporting data transfer rates up to 10000 Mbit/s and standard 10/100/1000Base-T(X) operation. The grey outer jacket provides a neutral appearance suitable for visible cabling runs.

Advantages

This Cat6 cable uses U/UTP construction to reduce interference and maintain signal integrity across longer runs compared with lower-category cables. Pre-terminated RJ-45 connectors ensure quick plug-and-play installation without tooling. The 15 m length provides flexibility in device placement while avoiding multiple couplers. Its lightweight design makes routing and handling easier during installation.

Suitable for

• Connecting PCs, switches and routers in home and small office networks
• Wiring networked devices in server rooms and network racks where a 15 m reach is required
• Temporary or permanent Ethernet runs for multimedia streaming, VoIP and file transfer

Key specifications

• Cable category: Cat6
• Shielding: U/UTP (unshielded pairs, overall unshielded)
• Connectors: RJ-45 to RJ-45
• Supported protocols: 10/100/1000Base-T(X)
• Maximum data rate (manufacturer-stated): up to 10000 Mbit/s
• Length: 15 m
• Colour: Grey
• Weight: 0.276 kg

How to use

Plug one RJ-45 connector into the Ethernet port of your device and the other connector into the corresponding port on a switch, router or wall outlet. Ensure connectors are fully inserted until the latch clicks to establish a proper mechanical and electrical connection. Route the cable to avoid tight bends and sharp edges; maintain reasonable separation from mains power cables to minimise potential interference. No additional configuration is required for standard Ethernet operation.

Recommendations

For optimal performance, avoid kinking the cable and keep bend radii larger than the cable diameter. Use the 15 m length to minimise the number of intermediate couplers or adapters. When installing in permanent or dense cable runs, label both ends to simplify future maintenance and verify link speed and duplex settings on network devices after connection.