Microconnect FIB440402P cable InfiniBand/fibra óptica 2 m LC violeta

The Microconnect FIB440402P is a 2 m OM4 multimode fibre optic patch cord with LC connectors on both ends. With a 50/125 µm core/cladding structure and full-duplex LC–LC terminations, this violet cable is designed for high-speed data links in data centres and network installations and is suitable for 10G/40G/100G Ethernet applications using SR and BIDI transceivers.

Advantages

OM4 multimode construction provides higher bandwidth and extended reach compared with lower-grade multimode fibres for 10G, 40G and 100G links. The cable uses LSZH jacket material for reduced smoke and toxic emissions in case of fire, and LC connectors ensure wide compatibility with SFP+, QSFP+ and other small-form-factor transceivers. The 2 m length and violet colour support tidy routing and easy identification within patch panels and cabling trunks.

Suitable for

• 10G SR and 10G multimode links with SFP+ transceivers
• 40G and 100G SR/BIDI connections with QSFP+ or compatible transceivers
• Data centre rack-to-rack and patch panel connections
• High-density fibre installations requiring LC–LC terminations

Key specifications

• Cable type: OM4 multimode fiber, 50/125 µm
• Connectors: LC – LC, duplex/full duplex
• Length: 2 m
• Jacket: LSZH
• Colour: Violet
• Weight: 0.02 kg
• Manufacturer: MicroConnect, MPN: FIB440402P, EAN: 5711045249549

How to use

Insert each LC connector into the corresponding LC port on the transceivers or patch panel until it latches. Ensure connectors and transceiver ports are clean before connection to avoid signal loss. Route the cable along designated cable trays or management channels, avoiding tight bends and compression. For duplex operation, maintain correct polarity by matching transmit and receive ports on both ends.

Recommendations

For best performance, use OM4 patch cords for multimode SR and BIDI transceiver links within their supported reach, keep connector endfaces clean using appropriate fibre-cleaning tools, and avoid bending below the manufacturer’s minimum bend radius. Use LSZH-rated pathways where low-smoke emissions are required.