Microconnect MC-SFTP80025S Cable de red negro 0,25 m Cat8.1 S/FTP (S-STP)

The MicroConnect MC-SFTP80025S Cat8.1 patch cable (0.25 m) provides high-speed wired connectivity for environments requiring up to 25 Gbps and wide bandwidth up to 2000 MHz. This S/FTP-shielded RJ45 cable includes gold-plated 50 µ" RJ45 connectors for stable contact, a latch protector to reduce the risk of clip breakage, and meter markings on the boot to quickly identify cable length. The cable is black and intended for short-links where high data throughput and reduced interference are needed.

Advantages

The S/FTP shielding minimizes electromagnetic interference and crosstalk, supporting reliable high-frequency transmission. Gold-plated 50 µ" RJ45 contacts improve conductivity and corrosion resistance. Latch protection extends connector life by preventing accidental clip damage, and the meter marking simplifies installation and management in rack or patch panel setups.

Suitable for

• Server room patching and short connections between switches
• High-speed data transfer at up to 25 Gbps
• Environments with potential electromagnetic interference
• Patch panels and rack-mounted network equipment

Key specifications

• Standard: Cat8.1
• Data rate: up to 40000 Mbit/s (supporting 25 Gbps applications)
• Bandwidth: up to 2000 MHz
• Length: 0.25 m
• Connectors: RJ-45 to RJ-45, gold-plated, 50 µ"
• Shielding: S/FTP
• Colour: Black
• Weight: 0.03 kg
• MPN: MC-SFTP80025S
• EAN: 5704174652267

How to use

Connect one RJ45 end to your network device (switch, router, NIC) and the other end to the target port or patch panel. Ensure connectors are fully inserted until the latch clicks; use the latch protector to avoid damaging the clip when unplugging. Use the meter marking on the boot to verify length during installation. For best performance, avoid tight bends and high‑stress routing near power cables.

Recommendations

For optimal long-term performance, install the cable in standard rack pathways, avoid sharp bends (minimum bend radius according to Cat8 guidelines), and keep S/FTP cables separated from strong electromagnetic sources. Replace the cable if connector damage or excessive wear is observed.