Microconnect UTP607R Cable de red rojo 7 m Cat6 U/UTP (UTP)

The MicroConnect UTP607R is a 7 m Cat6 U/UTP networking cable with RJ-45 connectors on both ends, designed for reliable wired connections between switches, routers, modems and wall outlets or patch panels. Tested to the Cat6 frequency of up to 250 MHz and backward compatible with Cat5e and Cat5, the cable supports high-speed data transfer up to 10000 Mbit/s and is suitable for small office, home networks and entertainment applications. The red outer jacket makes cable identification easier in multi-cable installations.

Advantages

This Cat6 cable provides tested performance up to 250 MHz and backward compatibility with Cat5e and Cat5 standards. The U/UTP construction and standard RJ-45 terminations ensure broad device compatibility, while the moulded snagless boots protect the connector tabs during installation in confined spaces. The 7 m length offers flexibility for routing between network hardware and wall outlets or patch panels.

Suitable for (tasks / use cases)

• Connecting switches, routers and modems to patch panels or wall jacks
• Small office and home Ethernet networks
• Streaming and entertainment devices requiring wired connections
• Temporary or permanent workstation cabling where a 7 m reach is needed

Key specifications

• Standard: Cat6, tested up to 250 MHz
• Length: 7 m
• Connectors: RJ-45 — both ends
• Shielding: U/UTP (unshielded twisted pair with overall unshielded)
• Data rate: up to 10000 Mbit/s (depending on network equipment)
• Colour: Red
• Weight: 0.26 kg
• Compatibility: backward compatible with Cat5e and Cat5

How to use

Plug each RJ-45 connector into the corresponding network ports on devices such as switches, routers, modems or wall outlets/patch panels. Ensure connectors click into place and route the cable to avoid sharp bends or compression. For installations in cabinets or through panels, use the moulded snagless boot to protect the latch during insertion. Test the connection with network tools or the connected devices to verify link speed and stability.

Recommendations

For best performance, avoid running the cable parallel to mains power lines and keep bend radius larger than the connector width. Use the red colour to mark specific links in multi-cable installations and verify that connected equipment supports the intended speeds.